DETAILS ON THIS OPEN FLAME BURNER FOR GAS LAMPS:
- IMITATES THE ORIGINAL GAS LAMP LOOK WITH FISH-TAIL FLAME
- ADDS DRAMA AND ROMANCE TO ANY OUTDOOR SETTING, ENTRANCE OR WALKWAY
- RELIABLE AND SECURE. WORKS EVEN WHEN YOUR POWER GOES OUT KEEPING YOUR OUTDOOR AREAS LIT.
- LOW-MAINTENANCE OPERATION
- WORKS FOR BOTH NATURAL GAS AND PROPANE LP GAS LAMPS
- MADE OF BRASS
PROPER LIGHTING PROCEDURE FOR OPEN FLAME BURNERS
STEP 1 | Remove the glass by lifting from the bottom with a forefinger, pulling out slightly, and lowering. NOTE: Proper combustion is essential. Do not obstruct air inlet or outlet vents.
STEP 2 | Use a screwdriver to slowly turn the gas ON and hold a match up to the burner. When lit, turn the gas on full.
STEP 3 | Replace the glass by fitting the top edge into the frame top, holding the glass against the tabs inside the frame. Allow the glass to slide into the frame bottom.
MAINTENANCE
Perform these simple maintenance tasks to keep your open flame lamps operating smoothly.
- Periodically remove glass panels and clean with hot soapy water or glass cleaner
- Remove debris at least twice per year. Removing debris will improve the performance by enhancing the airflow around the burner.
- Clean the open flame burner tip at least twice per year. Run a piece of fine dental floss or use a wire brush to remove any debris or soot that’s settled in the burner tip.
- Adjust the flame by inserting a flat head screwdriver through the valve access hole in the collar of the lamp. Turn the valve slowly to adjust the height and shape of the flame. Be careful not to turn the valve too fast or too far. This can cause the flame to extinguish. If the flame extinguishes, turn the valve to the OFF position and re-light.
NEED HELP?
We would be happy to help you find gas light lamps, torches or parts.
EMAIL US: We will get back to you same or next business day.
